NV41116E Multi-Camera Display View

[bmollo]

Having issue re-organizing my multi-camera display view (eg: View 16) into the proper order. Somehow I got them in this order:

D2 - D5 - D3 - D4
D1 - D6 - D7 - D8
...

I can't seem to figure out how to get D2, D5 & D1 back to the normal order:

D1 - D2 - D3 - D4
D5 - D6 - D7 - D8
...

I've tried removing all the cameras and re-adding them but the positions seem to be hard set. Does anyone have any suggestions or links to guides that explain this?

Thanks!!

[djcalcutt]

does it not support drag and drop?

Click drag the video to the square you want it.

[Revo2Maxx]

@bmollo Hello and Welcome to the Forum...

So are you talking about when your using WebUI or you talking about your Normal NVR in view outside of the normal single channel view?

ON the WebUIl you can Drag and Drop and if you were to Recall next time and don't have the setup the way you want it will load back the way it was last setup in View.. Is it that your using the WebUI and have it listed that way? THen you bring back in the same view?

[bmollo]

Aaaah ha!!! I figured it out... you have to right click and go to "Sequence", then and only then can you "drag and drop"!

Thanks @djcalcutt !

[bmollo]

Hey @Revo2Maxx - Thank you for your reply! So, it's on the normal NVR. It's not very intuitive. But I did finally figure it out as I mention in my previous post. Gotta go into "Sequence" to reorder them.