Second Bad Base Station and NO Video!
Second Bad Base Station and NO Video!
I bought a 960HD Four Camera System with two Dome and two Bullet BNC type cameras. All cameras were installed and powered up when the power supply was plugged in. I know they are receiving power because at night I can see red LEDs lite up on them. When I powered up the Base Station and the Cameras together there was no video displayed from any of the cameras. I see the four quadrants on my monitor and text that 720 but no video from the cameras. I contacted support and tried everything they could think of to isolate the problem. They decided I had a bad Base Station. I returned the base station and received another one from Amcrest. I installed the refurbished Base Station, power it and cameras up and still no video to display. It does say Video Loss in each quadrant on the monitor. Went through the troubleshooting process with support again and once again, they say I have another bad Base Station! Has anyone else had problems like this? It is weird, if I power up just the Base Station without powering up the cameras it responds the same as if I had powered up the cameras, VIDEO LOSS on all four quadrants! The only common thing is the Base Station!