Password Issue

[mike3080]

Hi, I'm new to Amcrest and this board...
I bought two IPM-722S cameras at an estate sale and began setting them up. I had to physically reset the first one (the only one I've worked with so far) by crossing the wires in order to log in to the web access page. I set new admin ID and password ID. I logged out of the web access page. Later, I logged into the page without problem (with new admin and PW) and changed a few minor settings. Then I set up the camera to work on Blue Iris software, and it works without problem. But then I realized I'd better check for a firmware update. I went to the camera's web page, but now I can't log in! As soon as I begin to type in the new admin ID I get a red warning: Invalid Login Credentials.
I don't get it. Do I have to start all over and use "admin" for the admin ID?
Thanks for any help!

[longedge]

I don't know anything about your camera but in general when doing the initial setup, you are required to change the default password. Are you saying that you cannot access the camera as "admin" using the password that you entered when setting up?