IP5M-T1179EW ONVIF reporting identical URL for Mainstream and Substream

[DataMeister]

The IP5M-T1179EW seems to have a problem in the ONVIF software where it reports the same URL for both mainstream and substream.

Code: Select all

rtsp://CAMERAIP:554/cam/realmonitor?channel=1&subtype=0&unicast=true&proto=Onvif

This shows up in NxWitnes, DWS Spectrum, and in ONVIF Device Manager, any of which can be installed for free to check it out for yourself.

Software Version V2.800.00AC000.0.R, Build Date: 2019-11-13
WEB Version V3.2.1.806712
ONVIF Version 18.06(V2.4.5.782676)

[DataMeister]

Also I just wanted to point out that the IP4M-1051 has the same problem.
Firmware: 2.620.00AC000.3.R, Build Date 2019-12-18
ONVIF Version: 16.12(V2.4.1.513183)

In NxWitness/DWSpectrum this has the negative effect of preventing it from doing motion record on the camera. The software disables motion record on anything 720p or higher to conserve CPU resources.

So until this firmware is fixed these cameras have limited functionality on those systems. All you can do is set it to record full time which is horrible on disk space and when searching for things later.

[Revo2Maxx]

Sadly I can't speak on what is or isn't going to work with Amcrest IP cameras.. I have been told by many of Amcrest support staff that ONVIF of Amcrest products are not Normal or Standard..

Oddly I thought this might be an issue with new FW cameras however looking over all my Amcrest cameras they all produce the same results besides 1 and that is my 956E that has old FW and another POE camera that has even older FW on it form 2013 or 2014 would have to look might even be 2012..

Prime Stream rtsp://10.0.0.218:554/cam/realmonitor?channel=1&subtype=0&unicast=true&proto=Onvif
Sec Stream rtsp://10.0.0.218:554/cam/realmonitor?channel=1&subtype=0&unicast=true&proto=Onvif

all others say the same other then 2 mentioned before sadly not sure

This is from my 956

rtsp://10.0.0.177:554/cam/realmonitor?channel=1&subtype=0&unicast=true&proto=Onvif
rtsp://10.0.0.177:554/cam/realmonitor?channel=1&subtype=1&unicast=true&proto=Onvif

[DataMeister]

"Oddly I thought this might be an issue with new FW cameras"

I have some older IP4M-1026W cameras that do not have the problem with firmware 2.420.0001.3.R, Build Date 2018-02-06.

[jack7]

I don't have your camera but see if this works better for you.

Code: Select all

rtsp://admin:password@192.168.1.127/cam/realmonitor?channel=1&subtype=1