AD110 Motion Detection Alarm Records

[mbster]

I have had my AD110 Doorbell installed for about 8 weeks now and using microSD card rather than cloud recording (yes, FAT32 formatted). For the first six or so weeks, the camera was recording to the SD card whenever it sensed motion. However, in the past two weeks, that has stopped. The SD card does record WHEN the doorbell is pressed, but not with just motion detection. Interestingly, whenever I reboot the doorbell, the motion detection alarm recording would work but stops doing so within a day and I would need to reboot again. This must be a software issue? Any help? Yes, the firmware is up to date and the device is still very new.

[amcrest168]

i have learned my lesson to only trust sandisk and lexar when it comes to reliable sd cards. if reboots don't work, then i would do a hard reset to its factory setting and start over. if the issue resurfaces, then perhaps it time to request a rma.

[mbster]

Yeah, I'm using sandisk microSD.

[amcrest168]

@mbster, i think you are right. it appears the motion detection recordings stopped on the doorbell. i think this could be a firmware issue. it wasn't like this with the previous firmware.