IP4M-1025E Manual, v1.0.3

[Vegaschips]

IP4M-1025E Manual, v1.0.3
5.2.2.5 (IP Filter). Page 38.
I entered my router's MAC address here as a "trusted" device. Now IP Config kicks me out when I try to log in. I can see the camera from my router but access is denied. Apparently, it is not "trusted". Is it possible to change this setting without performing a "hard" reset, i.e., removing the lens cover, etc?

[Melvin]

Hello Vegaschips ,

If you enabled 'IP filter' it will only allow you access the device from the specific IP. In your case routers IP? So unfortunately the only fix is to hard reset the camera.

[Vegaschips]

I thought so, just wanted to be sure. Thank you...