Amcrest Forum

Server down? Not very good for security.

Same for me. Not working. I wish my security cameras could work as they are intended for. 24/7 security. Not sometime security.

It's a pretty awesome feeling getting motion alerts, being in Iraq and not able to view my flipping cameras. Amcrest come on.

I cant even get this to work at all. When I log into amcrestview, it ask for my S/N from the system. When I enter that, just tells me its incorrect. Same with the app, Ive tried using both PSP Setup and IP/Domain setup (For the QCAM 3MP system). Every time I try, either says fails to connect, or timed out. Sure would be nice if they worked one day at least.

if you cant register your S/N, try doing a reset by holding the led down for 15-30 seconds and try again to register the camera.

Start View Live Failed to connect after camera was configured and "added". Anyone have any suggestions?

Same here. P2P "failed to connect" on all devices. Setup through domain and then I can't view live connected to my home network.

LiveViewPro uses the Extra/Sub stream so you need to make sure it is enabled on your cameras. I have had issues connecting over some WIFI networks so I disable WIFI on my IPhone and connect over cell, then it works. I also need to close the LiveView app after each use or it will not connect the next time I try to use it.

Jabber nailed it

Eh. Maybe not.

I spoke to Amcrest today. The P2P servers were down the last five days. Local and remote access changed too. They got all mine working again after 57 minute call.