Amcrest Forum

Posted: **Sat Jan 06, 2018 5:19 pm**

Hi,

I have the Amcrest AMDVTENL4 NVR that I am trying to connect via IP to my two Foscam IP cameras: a FI9800PR and a FI8919W.

They are set as ONVIF, and I have all of the IP addresses and login info entered into the NVR setup windows, but there's no video showing up on the NVR. Instead, it shows the IP address for the camera with the message "The login return time is up."

Any ideas on what's wrong?

Posted: **Fri Feb 09, 2018 10:59 pm**

I'm having the same problem... anyone?

thanks in advance!!!

R

Posted: **Thu Apr 12, 2018 12:33 pm**

If this is a wired IPC, most likely you have an issues with your Ethernet cable from camera to NVR or Switch or Router. Check the network cable. Also, make sure the IPC is powered properly with recommended power supply

Posted: **Tue Jan 08, 2019 2:00 pm**

Anyone find a solution or the cause? I’m having this issue.

Amcrest Forum

The login return time is up

The login return time is up

Re: The login return time is up

Re: The login return time is up

Re: The login return time is up