Amcrest Forum

I have 3 IP2M-841B cameras and am using PC-NVR. When one of the cameras detects motion all 3 of the cameras are recorded at the same time and for the same duration. This happens each time one of the cameras detects motion.

Is this right or am I missing something?

Thanks

Sorry this is abit old.

I just found out that the older version allow you to do that but the newer 1.4.1 do not let you do that anymore.

On the older version, you add PC-NVR as device and then to go DEVICE CONFIG and expand out the PC_NVR and click on the motion detection and then select the channel to record based on the trigger of the current channel(camera) selection.


Unfortunately,
This option is no longer available in the newer version. I don't know why they took it off.
Amcrest if you see this please bring this option back.

That's odd.