NV4108E-HS: How to capture/email multiple snapshots on motion event?

[uberspeck]

I have a IP2M-848EB connected to an NV4108E-HS. I want configure the NV4108E to capture and email a series of photos when the camera senses motion. I know it's possible, but I can't figure out how

[jack7]

The NVR interface apparently can't set more than one snapshot for an email. You could try this.
Run the ethernet cable from your camera to your router. To supply power to the camera, use the power supply that came with your camera, or use a POE power injector or switch.
Then put the camera IP address in PC IE and use the web interface to set up the camera. Specify 1,3,or 5 snapshots for an email. Test that with a motion detect event.
Then use the NVR interface to add the router attached camera to the NVR and see if the email/snapshots and recordings work properly.

[dcalcutt]

I believe the camera or NVR with send multiple email with one picture each.
So, if you have it set up for 5 pictures, upon a mothion dection, five emails will come with one picture each.
I though there would be one email with five pictures.

[jack7]

The post below appears to provide good insight into factors that determine snapshots per email:

https://amcrest.com/forum/technical-dis ... tml#p15996